New York Standard Watch Company
.
www.newyorkstandardwatch.com
NYSW
Instruction Manual
-
Atomic (Radio Controlled) 3 Hands watch for USA and Europe.
IM code: M55A
4. RED+GREEN light
fl
ashing at the same time indicates that the watch is currently not set to any USA time zone. This happens
when you travel abroad and your watch has been set to an overseas time zone outside USA.
5. To con
fi
rm a new USA Time Zone setting or Exit, press-release S3 once or the watch will Exit by itself after 30 seconds
6. The watch will run fast and adjust itself to the new time automatically after you have set it to a new USA Time Zone.
Wait until your watch runs normally (Running time vary from minutes to 40 minutes depending on the Time Zone Setting).
Please don’t press any button while the second-hand is fast running.
Reception OK or Fail Check
You can check your watch to see if it got signal during the past 24 hours.
1. Press-release S1 once while the watch is running regularly
2. If the reception was successful, the second-hand will pause at 12 o’clock
3. If the reception was failed, the second-hand will pause at 6 o’clock
Don’t push any button after the second hand has stopped. Wait until your watch runs again.
Checking Global Time Zone setting
1. Press and holding S3 button for over three seconds while the watch is running regularly. The second-hand will point at the current
Global Time Zone setting. Release the button and don’t press any button.
2. To Exit, just leave the watch alone until it resumes running normally.
TRAVEL AROUND THE WORLD
Your watch is able to receive time signals from USA, Germany, UK and Japan automatically according to your Time Zone setting.
Your watch will continue to work by using the last received signal as a reference if no local time signal is present in country where
you visit. When you go abroad make sure you set the right Time Zone according to the below setting procedures.
Set your Watch to a Time Zone outside your country
IMPORTANT:
Before change Time Zone, please press S1 (upper button) and see if second-hand point exactly at 12 O’clock or 6 O’Clock. If not,
please go to TROUBLE SHOOTING “Procedure to calibrate the shifted second-hand” section and do the re-calibration for the
second-hand
fi
rst.
1. Press and holding S3 for more than 3 seconds while the watch is running normally until the second-hand points at the current
Time Zone setting.
2. Press-release S1 once at a time to move the second-hand forward through the Time Zones according to the “Table of World Time
Zone versus the Second-Hand position”
3. After the Time Zone is set, press-release S2 hardly to con
fi
rm.
The second-hand will run fast and the watch will adjust itself to the correct time automatically after you have set the watch to a new
Time Zone. Just wait until your watch runs normally. (Running time vary from minutes to 40 minutes depending on the Time Zone
Setting).
Remark
Customer lives in US should use “USA Time Zone Setting” to set your watch to one of the USA time zones when you come back to
America from abroad.
