TROUBLESHOOTING:
Your watch is a very delicate and precise instrument. Although uncommon, sometimes hard knocks or vibra-
tions can cause the hands to move irregularly, and therefore display the incorrect time, although the internal
clock is keeping accurate time. You may notice this when checking for a successful reception (by press S1 once)
and the analog “Second-hand” position does not synchronize with the “Second” reading on the LCD (for
instant, the LCD reading is 29 second but the analog second-hands is pointing at 27 second). The 6 o’clock
reference point has changed and the watch needs to be re-calibrated.
Re-calibrate the shifted second-hand:
1. Make sure the watch is running normally.
Holding S3 (the upper left button) around 10 seconds until the second-hand stops at a new position.
2. The second hand may stop at the position mentioned below in A, B or C then release the button and follow
the steps below:
A.
If the second-hand stops between 12 to 6 o’clock (after second-hand stops)
1. Press S1 (the upper right button) one at a time until the second-hand points exactly at 6 o’clock
2. Press S4 (the lower left button) to confirm.
The watch will stop for a while. Just wait until the watch resume running.
B.
If the second-hand stops between 6 to 12 o’clock (after second-hand stops )
a. Press S4 and then wait for the watch to resume running.
b. After the watch runs normal. Repeat steps 1, 2 and A.
C.
If the second-hand stops exactly at 6 o’clock
this indicates that the second-hand was exactly 5 seconds left
shifted before alignment. No alignment is required. Just leave the watch alone until it resume running
.
Watch can’t Receive Time Signal
Reason for not being able to receive the Time Signal include:
-Watches being not place nearby a window
-Watch being not putting on a table with face-up or facedown manner
-Watch being place by its side
-Being outside of the UK, Germany, USA and Japan(60Khz) signal area
-Being in a build up area
-Metal objects blocking the radio signal
-Interfere by computer monitor or TV
New York Standard Watch Company
.
www.NewYorkStandardWatch.com
Page 6
2007 EN
NYSW
Instruction Manual
SOHO Series - P103A-01, P103A-02, P201-07, P201-08
(3 hands Analog-Digital Atomic Watch)
