Ensure the watch is left by a window, as this gives the best reception, you may have to try different windows in
the house to see which is best. You can test this using reception status test described earlier. Please note that
reception is always better at night.
If your watch is unable to make contact with the radio signal, it will continue to function in the same way as a
standard watch. The time will then be corrected the next time your watch receives the time signal.
Second Hand running non-stop
When battery is low, the Second Hand may run non-stop. Change the battery of the watch after it comes
to a stop.
Time is wrong
If your Time Zone setting is incorrect, your watch will show you the wrong time. You need to manually
set it to the right Time Zone. Go to “Time Zone Setting” for details.
Battery Change
You need to change a new battery if the watch stops, the LCD display becomes dim or the watch does
not function properly.
Battery type
This watch uses a CR2025 type battery, trained jewellers or watch specialists should fit new batteries to
avoid and damage to the watch.
1. Open the watch at the back. Carefully remove the bottom, make sure you are not losing the waterproof seal.
2. Pick up the battery spring.
3. Take out the battery and insert a new one (watch the polarity!”+”up).
4. Now push the battery spring down.
5. Before you put the case-back on again, make sure the waterproof seal is correctly in place.
After Battery replacement, you need to:
1. Align all 3 hands at 12 o’clock
2. Set your Time Zone (through City Name)
3. Put the watch to a location (window) where reception is possible for 24 to 48 hours to allow the watch to
receive radio signal to set the correct time.
New York Standard Watch Company
.
www.NewYorkStandardWatch.com
Page 7
2007 EN
NYSW
Instruction Manual
SOHO Series - P103A-01, P103A-02, P201-07, P201-08
(3 hands Analog-Digital Atomic Watch)
