IMPORTANT TIPS
1. If you have purchased more than one
wardrobe organiser, do the smallest or easiest
one first!
3.
Y
ou do not need to find a stud/nog when
mar
k
ing holes as our fittings are designed
to fit straight into the Gib board.
TOOLS REQUIRED
•
Tape Measure
•
Cordless Drill
•
Level
•
Pencil
•
5
.
5
mm Drill Bit
•
No. 2 Square Head Screw
Bit
2. This is a generic installation guide eg. no
matter what your shelving layout is, follow these
steps for installation.
4
. Go to nzwardrobes.co.nz/installation for online
installation videos (recommended}.
5
. The shelves can be cut down using bolt cutters
or an angle grinder if re
q
uired.
PLEASE NOTE:
Some parts may not be
required in your kitset.
A
�
A Shelving
B Wall Anchor
B
C End Wall Bracket
D Back Wall Clip
E Screw
D
SEE PAGE 10 FOR INSTRUCTIONS IF REQUIRED
F Support Bracket
F
C
2
E
*Support Bracket only supplied with shelves that span over 1200mm wide
G
Saddle Clip
G
PARTS INDEX
3 x Wall Anchors (B)
3 x Screws (E)
