Cleaning & Maintenance
1. The device should be protected from impact.
2. After use, contaminated components should be cleaned (Note: the body, base, and control panel should be protected from
water. DO NOT IMMERSE THEM IN WATER), and can be dried in the sun if possible to kill bacteria generated during bean
sprouting.
3. Clean and dust-free tap water should be used. Note: do not contaminate the water with grease; it will cause the sprout
rotten.
4. Keep the device clean, and empty the water tank if it is not to be used for a long time.
5. The device will build up dirt after longtime service; so a bit of table vinegar in the cleaning water will help to eliminate dirt
and sterilize the device.
6. Fault Analysis and Problem Shooting
FAULT
POSSIBLE CAUSE
PROBLEM SHOOTING
No water spraying
No water
Add water
Not energize yet
Check and energize
The water pump is blocked at the inlet port
Unscrew 4 screws to remove the strainer, and clean
the water pump
The water pump is damaged
Replace the water pump (contact the dealer)
The circuit board goes wrong
Replace the circuit board (contact the dealer)
Smaller Watering Flow
The pump has foreign matters at the inlet
Unscrew 4 screws to remove the strainer, and
remove foreign matters
The vane is blocked
Clean holes on the vane
The vane is damaged
Replace the water pump (contact the dealer)
The vane stops rotation
from time to time
The vane is blocked
Clean holes on the vane
The pump is blocked at the inlet port
Unscrew 4 screws to remove the strainer, and clean
the water pump
The water tank hasn’t renewed the water for
long time
Change the water
NOTE: When it is found that some beans sprout slowly, it may be caused by insufficient water sprayed by the vane that stops
rotation. In such case, vanes and water pump should be cleaned in a way as described above.
Recommended Recipes & Nutrients
Summary of Contents for ASB-88
Page 7: ......
