【
Example when mounting on the left side
】
【
reference
】
Installation
15
1.Remove the pair of front bolts (M4 x 15) on the generator mount, where you intend to fit the
Generator. There bolts are unnecessary in case the Generator is fit.
2. Bolt the Generator support (R) to Mounting plate(F)
together with 15mm Spacers using M4x25 Bolts. Fasten
only temporarily. The Generator support (R) piece has
two sides. Check this closely.
The alignment mark is roughly here when the belt is
new.
7. Fasten the M4x25 bolts of the Generator support (R) that you temporarily fastened earlier. Loosen
the Lock bolt of Generator support (F) and check if belt tension is adjustable by rotating the generator
body.
8. Rotate the generator body clockwise (viewing from the front of the engine) and adust the belt tension.
Press on the middle point of the belt with a finger and set deflection to around 2mm. Tighten the Lock
bolt after adjusting the belt tension.
3. Loosen the Lock bolt on the Generator support(F) and align the
marks as shown above in the red circle. Tension of the belt is the
loosest at this position.
4. Loop the belt over the Drive pulley
and the engine pulley.
5. Insert the Generator into Urethane
bushing of the Generator support (R).
6. Attach the Generator support (F)
to the Generator mount together
with 4.5mm Spacers using M4x30
Bolt.
Generator mount
1. (Please remove it.)
Urethane bushing
2. Generator support(R)
Mounting plate(F)
15mm Spacer
5.
7.
4.5mm Spacer
4.
6.Generator
support(F)
Lock bolt
3.
Generator support(F)
Summary of Contents for GF40U-FI
