The fire pit should lite fairly quickly. If not repeat Steps 1-4 until fire pit is lit.
Shutting Off The Fire Pit
3.
After the fire pit has completely shut off and is cooled down. Close the propane tank valve or
natural gas servicing valve to the "off" position to ensure no gas is leaking while not in use.
3.
Place a burning match or hold a lighter stick to the surface of the fire pit media that is covering
the burner. Do not hold the match by hand.
4.
After the match is burning or the lighter stick is lit and in position, push in the manual gas
control knob slightly, and slowly turn the knob counter-clockwise to the “ON” position.
1.
STOP - READ SAFETY INFOIRMATION ABOVE
1.
Push in the manual gas control knob slightly and turn clockwise to the “OFF” position.
2.
Wait 5 minutes for gas to clear out
2.
After the fire pit has been turned off, wait 5 minutes for gas to clear out
Page 11
5
OPERTATING INSTRUCTIONS
*We recommend that before you install your Fire Pit you familiarize yourself with the control valve layout.
This will help you to be confident operating the Fire Pit when fully installed (see figures below for typical control positions).
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY,
A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
BEFORE LIGHTING,
smell all around the Outdoor Fire Pit
area for gas. A rotten egg smell. Be sure to smell close to
the floor because propane gas is heavier than air and will
settle on the floor.
IF YOU SMELL GAS (A Rotten Egg Odor) FOLLOW THE
INSTRUCTIONS ON PAGE 1.
Use only your hand to push in and turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, DO NOT force it. DO NOT try to repair it. Call a
qualified, professional service technician. Force or
attempted repair may result in fire or explosion.
DO NOT
use this appliance if any part has
been under water. Immediately call a
qualified, professional service technician to
inspect the Outdoor Fire Pit and to replace
any part of the control system and any gas
control that has been under water.
Push in the manual gas control knob slightly and turn clockwise to the “OFF” position.
LIGHTING INSTRUCTIONS
