Zeta 10 Series Manual - V1.1
© Oak Stoves 2016
19
Maintenance
Fig. 5
Tertiary Plate Removal
Remove all M4 x 10mm long screws from the
Tertiary Plate
(see Fig. 5)
. You will then be able
to withdraw the Tertiary Plate from the firebox.
NOTE:
When replacing the plate you will need
to use a new set of M4 x 10mm screws.
Fig. 6
M4 Screws
Fire Brick Removal
1. With the Tertiary Plate removed, raise the
Baffle Plate and angle the top of the left hand
Side Fireboard to the right hand side to remove
it from the firebox. Repeat with the right hand
Side Fireboard.
2. Remove Baffle Plate and resting fireboard
from the firebox.
3. Remove M5 x 8mm socket screw holding
retaining clips and slide the Top Fireboard
towards the rear of the firebox until it’s clear of
location pins. Remove from firebox.
4. Remove Rear Fireboard.
5. Firebox is now ready to clean
NOTE:
All screws removed at this time must be
renewed.
Baffle Deflector
Plate
Side Fireboard
Retaining Clip
Throat Plate
Fireboard
Rear Fireboard
Fire Brick Assembly
1. Place Top Fireboard against the roof of the firebox and slide forward over the location pins
then fix in position with Retaining Clips using two M5 x 8mm long socket head screws.
2. Place Rear Fireboard in position and centralise.
3. Put Baffle Plate along with the resting fireboard into the firebox. Rest the rear of the Baffle
Plate on the Tertiary Bar and hold in position.
4. Put one of the Side Fireboards into the firebox, position it at the bottom on the Riddler Plate
first then swing the top up carefully while simultaneously raising the front of the Baffle Plate,
position the Side Fireboard and carefully let the baffle plate down into position. Repeat with
opposite side.
Ins
talla
tion Ins
tructions
