Assembly Instructions
Black Stamped Steel ‘T’ Table Bases
1. Flip your tube/spider
so the spider is on the
ground and the bottom
of the tube is facing up.
2. Screw out the short
bolt in the bottom
of the tube/spider.
4. Using the socket set
or crescent wrench,
screw in the short
bolt with lock washer
and flat washer into
the tube
3. Place the ‘t’ foot on
the tube.
5. Locate the leveling glides and
screw into the welded end tabs
of the ‘t’ foot.
6. Your table base
is now ready to
be mounted to
the table.
7. Place the table
base onto the
bottom side
of the table.
Crescent wrench
or socket set
Drill driver or
screwdriver
Tape measure
What you will need for assembly:
What’s in the box:
(8) 3/4” #10 screws
per base