10
|
TIME BOMB
®
II INSTRUCTION MANUAL
TIME BOMB
®
II INSTRUCTION MANUAL
|
11
TO AdjuST ThE TimE ANd dATE FOr SuBSEquENT SETTiNgS, uSE ThESE ShOrT prOCEdurES
TO SET THE TIME
1. Pull the crown out to the second click position (b).
2. Turn the crown until you reach the correct time.
3. Push the crown back down.
TO SET THE DATE
1. Pull the crown out to the first click position (a).
2. Turn the crown until you reach the correct date.
If the current time is between 9 PM and midnight,
set the date to the following day. (This is necessary
to ensure the date display will normally change at
midnight instead of 12 noon.)
3. Push the crown back down.
Time Bomb
®
II converts every movement of your wrist into energy that is stored mechanically. Daily wear
will keep it continuously charged with energy. The design prevents overcharging, no matter how long the
timepiece is worn.
If Time Bomb
®
II has rested idle for an extended period and the stored energy is depleted, the timepiece
can be started quickly with a few movements of your wrist. Move it back and forth at a pace of twice per
second.
STANdBY mOdE
After the stored energy reaches full capacity, Time Bomb
®
II will continue to run for approximately 38
hours with no additional movement. If you are not planning to wear the timepiece for an extended period
and you wish to leave it stored with mechanical energy, pull the crown out to the second click position (b)
to put the timepiece in Standby Mode
BANd AdjuSTmENT
If links need to be removed from the band, an Authorized Oakley Timepiece Dealer should do the adjustment.
Do not attempt to shorten the bracelet by removing links yourself, as this may result in damage.
CLEANiNg
Failure to keep the case and bracelet clean may result in a skin rash. Use a soft, clean cloth to wipe off
any moisture that adheres to the case or bracelet.
SETTING THE DATE AND TIME
your Oakley timepiece has a push-down crown
with a dual seal for added protection against
moisture. The crown can be pulled out to two click
positions for setting the date and time. After setting
is complete, push the crown fully against the case
to maintain moisture resistance.
To set the date and time the first time (or to reset
the date and time), do the following:
1. Pull the crown out to the first click position (a).
2. Turn the crown until yesterday’s date appears.
3. Pull the crown out to the second click position (b).
4. Turn the hands forward until today’s date
appears, then continue forward until the current
time is reached. If the current time is in the
afternoon or evening, move the hour hand all the
way around the dial to pass 12 noon.
5. Push the crown back down.
To set the exact second, wait until the hand that
counts seconds reaches the zero mark (at the top
of the dial) before you pull out the crown. Set the
time then wait until the exact second is reached
before pushing the crown back down.
Minute Hand
Hour Hand
Date
Second Hand
Crown
a
b
