Instruction Manual
CyberScan pH 11 / 110
6
3.2 Connecting the pH Electrode Temperature Probe & Electrode
Holder
The pH 11/110 meter uses any standard pH, ORP, or Ion Selective Electrode (ISE)
with a BNC connector. For Automatic Temperature Compensation (ATC), this meter
requires a temperature probe with a phono-jack connector.
NOTE: It is important that water does not get into the BNC connector. Also avoid
touching the connector with soiled hands.
3.2.1 To connect pH, ORP or ISE electrode
1. Insert the BNC connector
from the electrode over the
BNC connector socket on the
meter.
2. Make sure the slots of the
connector are in line with the
posts of the socket.
3. Slide the BNC connector of
the electrode over (Figure 5).
4.
Rotate the connector
clockwise until it locks.
5. To remove electrode, push
and rotate the connector
counterclockwise.
6. While holding onto the metal part of the connector, pull it away from the
meter.
7. Be careful not to use excessive force.
CAUTION: Do not pull on the probe cord or the probe wires might disconnect.
Refer to section 15 LIST OF ACCESSORIES section on page 65 for information on
temperature probe and other electrodes.
Figure 5: Insert the BNC connector from the
electrode cable into the BNC socket on the meter.
