The Receiver
Chapter 4
181
Note:
You can also use a magnet antenna (refer to Chapter 5).
4.3.
LED Indicators
Two LED indicators are used to indicate the Receiver’s status by
flashing. The indicators are located on the Receiver’s front panel.
The upper LED is marked DATA and the lower LED is marked
RF.
The RF indicator lights up red whenever the Receiver receives RF
carrier of the operating frequency (433MHz in Europe or 915MHz
in the US).
The DATA indicator lights up green whenever the Receiver
receives OaktonLog data.
The upper LED also represents the power supply and lights up
yellow whenever the Receiver is connected.
Summary of Contents for TempLog
