If Table Will Not Sit Flat on the Floor:
The table is equipped with Leveler Feet that adjust to level the table on uneven floors. To
adjust the Leveler Feet to suit common floor differences you will need to use a 1/2” open-end
wrench or an adjustable wrench. Adjust each leg individually in turn by adjusting the height of
each leveler foot until the unit rests level and steady. This adjustment will not effect the function
of the table
.
1/2” Open-end Wrench
Leveler Foot
This product is equipped with an interior 120-volt 60Hz accessory outlet. The
total electrical load of equipment plugged into this set of outlets is not to exceed
7 amps or 840 watts. Voltage will be different for other counties.
DANGER
This product offers an in-cabinet plug to accommodate hot towel cabinets or other accessories. This al-
lows you to store the unit inside with no excess cords to get in the way. With it plugged in, your towels
stay warm and within easy reach, yet are still out of the way. You will find the plug inside the cabinet
at the head end of the table. Simply plug the warming cabinet in and move any excess cord inside the
wooden cabinet.
Note: Appearance of outlets will vary depending oncountry of use.
INSTALLATION
IN CABINET OUTLET
LEVELLING INSTRUCTIONS
7
