10
DIRECTIONS FOR USE
CARBON FIBER ARM BOARD (ACCESSORY)
CAUTION
Do not place undue weight or downward pressure on the Carbon Fiber Arm Board. It is a position-
ing device for the arms and should not be used as leverage to get on or off the table. Injury can
occur. DO NOT exceed 30 lbs. (13.6 kg.) of load on the
Support Section.
Injury can occur.
Use
This radiolucent device can be used with any flat support surface where ionizing radiation (x-ray) is utilized for imaging.
It can be used to support arms and feet.
Directions
Unfold the Arm Board and slide the
Base Section
under the patient and the table pad. Position the patient and the
Support Section
to suit the needs of the procedure. The weight of the patient will hold the Arm Board in place.
Rotate the
Support Section
to the desired position. This section rotates up to 180º.
Prone Position at 135º
Supine Position at 180º
Support Section
Base Section
To remove the Arm Board, ask the patient to move their limb off the
Support Section
and lift their body slightly. This
will allow you to pull out the base section of the Arm Board.
Fold the
Base and Support sections
for storage.
FLUORO EXTENDER (ACCESSORY)
CAUTION
Do not place undue weight or downward pressure on the Fluoro Extender. It is a positioning device
for the arms and should not be used as leverage to get on or off the table. Injury can occur.
The Oakworks
®
Fluoro Extender is radiolucent and offers extra width only where you need it for great-
er positioning accuracy with optimum imaging. The Fluoro Extender is inserted under the table top
pad.
