- EN -
13
Product Description
LunAqua Power LED XL is a sturdy spotlight with LED lamps permitting simple and safe operation above and below
water (up to 4 m).
Accessories
LunAqua Power LED Cable 10 m (42636) as extension cable between driver and spotlight.
Intended use
Exclusively use the LunAqua Power LED XL as follows:
•
For use in water fountain systems and ponds.
•
For use above and under water.
•
Operate in accordance with instructions.
•
Connection to a suitable OASE driver.
Installation and connection
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
•
Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
•
Isolate the device (disconnect from the power supply) before carrying out any work on it.
N O T E
The unit is sensitive. Hard impacts and vibrations may damage mechanical or electronic components.
•
Protect the unit from hard impacts or vibration.
The device can be installed in or outside of the water.
•
Never cover the unit, as this will result in a risk of fire.
•
For installation outside of the water, keep a minimum safety distance of 50 cm from combustible material.
Place the unit horizontally on the ground ensuring its stable position.
•
A ground stake can be used for installation outside of the water.
Installation with the ground stake
How to proceed:
B
1. Insert a square nut into the spotlight on both sides.
2. Turn the clamping screws into the square nuts by several rotations, then insert the spotlight in the holding fixture.
– If necessary, adjust the tilt of the
spotlight. (→
Adjusting the tilt of the spotlight)
3. Tighten the clamping screws.
4. Insert the ground stake in the ground.
5. Install the unit on the ground stake.
Summary of Contents for LunAqua Power LED XL 3000 Flood
