- EN -
19
Addressing via DMX
DMX (Digital Multiplex) is a standardised digital transmission protocol used in stage and event equipment as well as in
many Oase components.
The DMX Channel and the mode can be changed by means of a DMX controller from OASE. Read the corresponding
operating instructions.
Description
Value
Serial No. (SN)
Enter the unit serial number. The serial number
is indicated on the label next
to the type plate.
Product ID
121
Version No.
1
DMX Channel
The factory-set DMX channel
is indicated on the label next to the type plate.
Configuration mode
1 = Set DMX starting address.
Config. mode
Description config. mode
Transfer value
Description transfer value
1
Set DMX channel
x
Function
x + 0
Speed
x + 1
Operation
Overview DMX parameters
Two channels are required for controlling the pump. The first channel is defined via the OASE DMX controller. The se-
cond channel is incremented and defined automatically.
•
The first possible DMX starting address is 1.
•
The last possible DMX starting address is 511.
Channel
Description
Value
DMX C 0
Pump OFF
0 ... 10
Control mode (do not use)
11 ... 49
Speed control
50 ... 99
Speed control, characteristic line compensation
100 ... 149
Not in use
150 ... 239
Reset error (→ Reset error)
240 ... 255
DMX C 1
Speed default value
0 ... 255
Reset error
How to proceed:
1. Use DMX C 0 to set a value between 240 and 255.
2. Use DMX C 0 to set a value between 0 and 10.
– The error has been reset.
3. Access the pump with the desired value.
Information on show programming
Switch-on/switch-off cycles
•
Only switch on the pump max. 1 x per minute.
•
Wait for at least 10 seconds between switching off the pump and switching it on again.
Switch-on sequence:
Step
Description
Channel
Values
1
Pump rotational speed set to minimum
DMX C 1
0
2
Control mode ON
DMX C 0
50 ... 99
3
Waiting time 1-3 seconds
–
–
4
Effect
DMX C 1
1 ... 255
Switch-off sequence:
Step
Description
Channel
Values
1
Pump rotational speed set to minimum
DMX C 1
0
2
Pump OFF
DMX C 0
0 ... 10
The DMX-C 0 (Control Channel) may not be changed during a show. The effects are exclusively programmed
via the DMX-C 1 (Speed Channel).
Summary of Contents for Varionaut 150 24V/DMX/02
