17
SECTION 5: TRIM BEZEL INSTALLATION (FOR SURFACE MOUNT MODELS)
A.
B.
C.
D.
A.
B.
Install frame assembly to a flat surface. Use appropriate fastening hardware (not
included). Refer to rough-in for correct installation height.
Remove Bottom Plate from Trim Bezel (4 screws)
Install Trim Bezel around the Frame Assembly and replace Bottom Plate with screws.
Place drip tray in frame but do NOT fasten in place. Do NOT place grille on tray at this
time. Install Snap Bushing and any other accessories included.
Uncoil EBQ push button wire lead and route through same opening in frame as the tubing.
Install Upper and Lower Front Panel. Install drip tray grille using 3 flathead screws,
provided.
Optional
Filters
Trim Bezel
(For Surface Mount
Units Only)
Upper Front
Panel
Frame
Assembly
Lower Front
Panel
Trim Bezel
Bottom Plate
with Screws
Fastening points on frame
(four, 5/16” mounting holes
on top and bottom rear
flanges
*
*
*
*
*
*
SECTION 6: PANEL INSTALLATION
Summary of Contents for MWEBQ
Page 21: ...21...
