Oasis MWEBQ, User Manual

4

IMPORTANT REQUIREMENTS

QUASAR UV-C LED OPERATION

CAUTION: 

Ensure bottle filler is properly grounded.  It is required to attach the 

long green ground wire to the frame assembly junction box in order for the unit 

to function properly.  Refer to the steps described in Step 4 on Page 12.

CAUTION:

 Do not activate bottle filler electric eye sensor without running 

water through the UV-C module.  Operating the UV-C module dry may 

damage the UV-C LED’s.

A.

B.

C. 

D.

E.

QUASAR is a form of dispense point water treatment that utilizes UV-C LED’s to inactivate 

pathogens. 

Operation:

The QUASAR activation is automatic.  The UV-C LED’s turn ON when water is dispensed 

and OFF when the dispense stops.

During non-use periods the QUASAR automatically cycles ON for ten seconds every ten 

minutes.  This keeps the dispense point more sanitary between use.

When the QUASAR is ON, the LED light on the front of the alcove near the top will turn 

ON.  The LED will be BLUE when the QUASAR is working properly.

If QUASAR is not working properly, then the LED light on the front of the alcove near the 

top will be RED or YELLOW.  The light will remain ON and the system will not allow water 

to be dispensed until the problem is resolved.

IMPORTANT:

  Never operate the QUASAR without water connected to the system.  Lack 

of water can cause the QUASAR to overheat.  If it is necessary to activate QUASAR to 

purge the system of air, then the QUASAR will automatically shut off if it overheats.  But 

the module will resume operation once water begins to flow through it.