4
u
Mold/Mildew: Liquid mildew remover or
baking soda and water paste. (Apply paste
and allow to fizz several minutes.) (Rinse
surface thoroughly)
u
Construction Adhesive: Soften adhesive
with a hand held hair dryer and peel off
adhesive. (Caution is advised when using
any electrical device near water.)
For adhesive residue, apply rubbing alcohol
or nail polish remover, full strength. (Rinse
surface thoroughly)
WARNING!
BATH MATS AND OTHER ITEMS HELD IN
PLACE USING SUCTIONS
MUST BE REMOVED FROM THE UNIT
SURFACE AFTER EACH USE.
OVER AN EXTENDED PERIOD, FAILURE
TO REMOVE
SUCTION ATTACHED ITEMS WILL DAM-
AGE THE UNIT SURFACE.
Nailing Flange
Wall Framing
Drill 1/8 inch hole through
flange at each framing member
Illustration 4 - Securing Unit
Wall
Framing
Secure unit to
framing with
large headed
fasteners.
CAUTION: Protect unit surface
with a shield when fastening.
Nailing Flange
Illustration 5 - Securing Unit
Water Resistant
Underlayment
Waterproof
Sealant
Furring Strip or
Shim Material
Nailing
Flange
Wall Framing
Illustration 6 - Wall Finishing
