•
To change banks from MIDI, push (or pull) the Master
controller's Vibrato or Modulation wheel, lever or joystick (MIDI
controller #1) to its maximum position.
While holding
the
Master's Vibrato control at its maximum, select a patch from O
through 9 on the Master. The bank of the same number is
recalled on the Matrix-1000. For instance, suppose patch
322
is
selected on the Matrix-1000. Hold the Vibrato control and select
patch 4 on the Master. The Matrix-1000 selects bank 4, so the
patch changes from
322
to
422.
If your Master has patch numbers which start at 1 rather than O,
then patch 1 selects bank 0, patch 2 selects bank 1, etc.
•
In short, whenever the Matrix-1000 sees a MIDI Patch Change
when the Vibrato or Modulation (MIDI controller #1) is more than
half way on, it uses the patch number as a
bank
number. So be
careful
if you're playing notes with your Vibrato on, and you
make a Patch change, the Matrix-1000 understands that as a
bank change command. To allow bank changing without using
Vibrato, MIDI controller #31 performs the same function. This
mode is the same as that found in the Oberheim DPX-1 and
some other instruments.
•
If
bank lock
is turned off, the Matrix-1000 will receive patches
000
through
127
over MIDI . If a bank change is sent from MIDI,
using either the Vibrato or MIDI controller #31, the Matrix-1000
turns on
bank lock
automatically.
MIDI patch changes are transmitted and received by the Matrix-1000
on its Basic Channel. Patch changes and bank changes are re
ceived by the Matrix-1000 in
all
front panel modes, not just
Patch.
Matrix-1000 Owner's Manual
19
Summary of Contents for Matrix-1000
Page 1: ...0 NER S MAN UAL scanned at www wolzow com...
Page 5: ...4 Matrix 1000 Owner s Manual...
Page 15: ...14 Matrix 1000 Owner s Manual...
Page 64: ...scanned at www wolzow com...
