19
OB-X8 User’s Guide
Oscillators
34 . Reset Globals:
Sets the global parameters to the factory default
settings. You can also hold the
write
switch and press the
global
button
to achieve the same result.
35 . Full Calibration:
Select and press
write
to fully calibrate the
OB-X8’s VCOs, VCFs, and VCAs. The main display shows calibration
progress, voice by voice.
36 . Lever Calibration (Keyboard only)
:
Allows you to calibrate the
pitch and mod levers. Follow the directions on the display, and hit
write
after each step. This should only be necessary if the range and/or center-
ing of the levers do not seem to be functioning correctly.
Oscillators
Oscillators provide the raw building blocks of the OB-X8’s sound by
producing
waveforms
, each of which has its own inherent sound character
based on its harmonic content. The OB-X8 has two oscillators per voice.
Each discrete oscillator generates sawtooth, pulse, and triangle waves. The
square wave can be set to match OB-X/Xa or OB-8 level characteristics
using Page 2. You can vary the pulse width of both pulse waves simultane-
ously using the
pulse
width
knob, or the LFO from the Modulation section.
You can set the individual pulse widths for Osc 1 and 2 by holding the Osc 1 or
o
sc
2
pulse
switch and turning the
pulse
WIdth
pot. The Pulse Width of each oscillator
can also be adjusted individually on Page 2.
Oscillator 2 can be hard-synced to Oscillator 1 for complex, harmoni-
cally-rich sounds when modulated. You can also cross-modulate Oscilla-
tor 1 by Oscillator 2’s sawtooth wave, for further shape-bending.
The X-Mod on/off provides sawtooth cross modulation just like in the original
OB-X. You can alternatively, or simultaneously, cross-mod Oscillator 1 by Oscillator 2’s
triangle wave using the Page 2 Osc 2 Tri. XMod parameter.
Oscillator 2 can be modulated by the Filter Envelope with the F-Env on/off
switch, just as on the original OB-Xa and OB-8.
Summary of Contents for OB-X8
Page 1: ...USER S GUIDE www oberheim com ...
Page 8: ...viii Oberheim ...