55
OB-X8 User’s Guide
Chapter 3: Page 2 Parameters
21 . LFO Sample/Hold In:
This parameter selects the input for the
Sample/Hold LFO: noise or the selected Lever Box Vibrato LFO
waveform. On the OB-8, these two choices were made with additional
combinations of the LFO waveshape buttons, where the OB-X8 imple-
mentation makes more clear that the selection is between two sources of
sample and hold.
22 . LFO Shift Voice 5-8:
This parameter is used to set the LFO phase
shift of voices 5 thru 8 relative to the LFO of voices 1 thru 4. The choice
of phase shift amount are None, 90 Degrees, or 180 Degrees. This
parameter is ignored if
lfo
keybd
track
is on, or if
lfo
env
mod
is on,
since the speeds of the LFOs for voices 1-4 and 5-8 will no longer be
synchronized.
23 . Vibrato LFO Wave:
This parameter allows selection of the Vibrato
LFO waveform (as found on the Lever Box.) Available waveforms are:
• Triangle
• Square
• Saw Up
• Sample and Hold
• Saw Down
• Noise
The OB-8 was also able to select these vibrato waveforms, but through a
cumbersome method of holding the pitch bend lever while pulling up on
the Depth knob.
24 . Mod 1 Delay Time:
Mod 1 delay time sets the time before ramping-
up of LFO modulation’s
depth
1
amount begins. The available range is 0
to 4.5 seconds on a linear scale.
25 . Mod 1 Attack Time:
This parameter sets the attack rate of a simple
attack-only envelope (or ramp) to control
depth
1
amount over time.
Range is 0 to 4.5 seconds on an exponential time scale.
26 . Mod 1 Env Type:
Allows Mod 1 Delay/Attack envelope to be
inverted. This allows for fade-out, rather than fade-in, modulation enve-
lope shapes.
Summary of Contents for OB-X8
Page 1: ...USER S GUIDE www oberheim com ...
Page 8: ...viii Oberheim ...