Installation Instructions
Model 1020-RAB-PMK
(877) 867-2312
•
www.oberonwireless.com
Part Number 2866, 10/12/2016
Oberon, Inc.
•
••
•
1315 South Allen Street
•
••
•
State College, PA 16801
Copyright 2014
Figure 2 - Right Angle Bracket
Figure 3 - Enclosure Install
Assembly Components:
- Polycarbonate Enclosure – 1 each
- Right Angle Bracket – 1 each
- T-Bar Bracket – 1 each
- Pole Mount Bracket – 1 each
- M4x0.7 x 10 screw – 4 each
- M4x0.7 x 20 screw – 4 each
- #6 - 32 x 1/4" screw – 4 each
- #6 - 32 x 7/8" screw – 2 each
- Nylon Spacer – 2 each
- Worm Gear Clamp – 2 each
- #10-32 x 3/8 screw – 4 each
If any of these items are missing, contact your Oberon representative.
Step 1 – Slide the Worm Gear Clamps through the slots of the
Pole Mount Bracket, and fasten the clamps around the pole
(Figure 1). Note, the included clamps only work for poles ranging
from 5 inches to 9 inches diameter.
Step 2 – Fasten the Right Angle Bracket to the Pole
Mount Bracket using the provided #10 screws (Figure
3).
Step 3 – Fasten the enclosure to the Right Angle Bracket
with the provided M4 x 10mm screws.
Step 3 – Route any cabling as needed, and install the
access point with the provided #8 plastic screws. A set of
nylon spacers and longer screws are provided to increase
the height of the T-Bar if necessary. Screw on the cover to 8
in-lbs for a proper seal using the provided M4 x 20mm self
captured screws (Figure 3). Installation is complete.
Figure 1 - Pole Mounting Bracket
Figure 4 - Access Point Install
