32
Before the very first ironing it is important to iron an old cloth or dishcloth to make sure that
all possible impurities in the water tank are removed. It is important to completely empty
the water tank before ironing. Some of the parts of the iron have been slightly lubricated/
greased, which may create some smoke when switching on the appliance for the first time.
After about 10 minutes the completely harmless smoke will disappear.
When steam ironing at low temperatures some dripping may be seen from the soleplate as
the water in the tank will not evaporate sufficiently. Therefore, always be sure to set the steam
selector corresponding to the temperature setting.
Before ironing, in particular for the first time, we recommend to pump the spray and burst of
steam buttons 3 to 4 times in order to activate these functions.
Burst of steam
Make sure that the water tank is at least
¼
full of water). Set the temperature in the wanted
position on the steam scale (•••), and wait until said temperature has been reached (wait until
the thermostat goes out again).
Lift the iron from the garment and press hard on the burst of steam button. The soleplate will
now release a powerful burst of steam onto the garment. It may be necessary to activate the
burst of steam button a couple of times in order to ensure the optimum power of the pump in
the iron. Wait a few seconds before reactivating the burst of steam button.
Note that the burst of steam can be activated at high temperatures.
IMPORTANT!
The steam is hot when you use the burst of steam, and therefore keep children
away to avoid burns. Keep your fingers off the steam jet when this function is on.
Vertical Ironing
The iron can also be used for vertical ironing, which is perfect for removing creases on
hanging clothes, curtains etc. The process is the same as for burst of steam (see that
section), but the iron is to be held in a vertical position about 15 to 30 cm away from the
garment to be ironed.
Dry Ironing
Switch the steam selector to position “0” (closed). Set the temperature at the wanted
temperature and wait until the thermostat light goes out. The iron is now ready for use.
If there is water in the tank, you can also use the spray function and the burst of steam
function (see special sections) when dry ironing, if this is required in order to obtain a good
result. Just make sure, when using burst of steam during dry ironing that the temperature
regulation has been set at this function.
Spray
Spray (atomisation of water) is used to dampen dry garments and difficult creases. Press the
spray button all the way down, and water particles will be sprayed on the garments for easier
ironing and a better result.
It can also be an advantage to use the spray function for delicate fabrics (synthetic fabric)
that are ironed at low temperatures and where you cannot use a specific burst of steam.
