You can also clean the blender jug (4) by pouring around 3 dl of water into the
jug along with a few drops of washing-up liquid and then running the pulse
function for 30 seconds. Then rinse the jug carefully with clean water.
Place the jug upside down and unscrew the blade unit (6) by turning it
anticlockwise. Clean the blade unit separately as follows: lift the blade unit
out of the jug and remove the seal (5) from the blade unit using the end of
the supplied cleaning brush (10). Carefully hand wash the blade unit and seal.
Then dry. Note that the blades are very sharp.
Be careful when replacing the seal (5) to ensure
it is in the right position in the blade unit (6) after
cleaning. If it is placed upside down, it will not be
possible to place the blender jug on the motor unit
correctly. The appliance cannot then be started.
Troubleshooting
The blender will not start.
a) Ensure that the blender jug (4) is
correctly positioned. A beep will
be heard when the jug is correctly
positioned.
b) Make sure that the grey seal (5)
is in the correct position in the
blade unit.
The vacuum pump is not working.
a) Ensure that the vacuum pump
(8) is pressed firmly down in the
vacuum lid (2).
b) Ensure that the vacuum pump
(8) is fully charged. See under
“Charging the vacuum pump”.
c) Check that the green silicone
valve in the vacuum lid (2) is
closed.
Disposing of the appliance
By law, electrical and electronic equipment must be collected for the
recycling of components. Electrical and electronic equipment marked
with the waste management symbol must be disposed of at a municipal
recycling point.
63
