Use without distance comb
If you want a cropped result (1 mm), you can use the
appliance without a distance comb and only use the trimming
head. Remove the distance comb from the appliance by
pressing the adjustment button of the comb and pushing
the comb upwards (see fig.) Turn on the appliance by
means of the switch. Hold the appliance with the trimming
head upwards to have the flat side of the trimmer facing
towards the head. Start at the neck and move the hair clipper
upwards in soft movements and continue in this way all over
the head. Be extra careful around the ears. Switch off the
appliance by means of the on/off button after cutting.
Cutting by means of fingers/comb
• Use your fingers and/or comb to cut hair sections longer than 41 mm.
•
Remove the distance comb from the appliance by pressing the adjustment
button and push the comb upwards.
• Lift a hair section with an ordinary comb or hold it between your fingers to
have excess hair stick up over your fingers.
•
Cut the hair with the hair clipper. Continue in this way until the wanted length
has been obtained.
•
Comb regularly to remove loose hair and to check the result.
Cleaning and maintenance
Always switch off the clipper and disconnect it from the adapter before
cleaning.
•
Remove the distance comb from the appliance by pressing
the adjustment button of the comb while pushing the comb
upwards. The distance combs should be cleaned with water
and a drop of mild detergent.
•
You can rinse the clipping unit under running water for
a quick cleaning. However, the temperature of the water
should not exceed 70°C. Press the ”Lift & Wash” button to
release the clipping unit.
•
Keep the hair clipper under running water to make the
water run through the opening of the clipping unit. Please
note that the hair clipper is not absolutely waterproof and
should not be immersed in water or other liquids. Let the
hair clipper dry before you press down the clipping unit
again.
36
37
