32
•
= Ironing at low temperature: Synthetic fabrics, e.g. acryl, nylon, polyester etc. Steam
ironing cannot be made at a low temperature. Set the steam selector at
.
••
= Ironing at medium temperature: Wool, silk etc. Steam ironing can to a certain de-
gree be done by setting the steam selector at ” ”.
•••
= Ironing at high temperature: Cotton, linen, flax etc. Steam ironing can be done by
setting the steam selector at
.
If the garment has print, sequins or similar, special care is required as such materials may
melt. Consequently, the above table is not valid for such materials. We recommend that fa-
brics that have a tendency of becoming shiny are ironed on the reverse side. If ironed on the
right side, do it carefully and always keep the iron moving.
Filling with water
If you want to use the iron with steam, start by filling water direct from the tap. Do not use
distilled or demineralised water as such liquids may combine with the metal parts of the iron.
Using other liquids than tap water may damage the iron and may furthermore result in black
spots on the garment to be ironed. Damage to garments due to the use of other liquids than
tap water is not covered by the warranty and possible use of other liquids can be ascertained
by our repair shop.
If you live in an area with very hard water (above 17 dh), you should clean the steam cham-
ber of the iron regularly in order to avoid lime deposits. Follow the self-cleaning process as
described in this manual. The iron is furthermore equipped with a built-in anti-calc filter (not
replaceable), which has been designed to reduce the building up of limestone in the steam
chamber and thus to prolong the lifetime of the iron. The anti-calc filter will, however, not
entirely prevent the natural building up of limestone in the iron, and it is therefore important
to follow the self-cleaning procedure at regular intervals.
Remove the mains plug from the electrical outlet and pour water into the delivered beaker.
Set the steam selector at
. Put the iron on its heel on a level surface and open the filling
inlet by pulling the lid backwards.
Pour the water slowly into the filling hole. The water level must not exceed the Max indication.
Close the lid to the filling inlet. NOTE: If you are going to steam iron afterwards, it is important
that the iron is heated before switching the steam selector to steam ironing. Close the lid to
the filling hole.
The iron has an alarm indicating when the water tank needs refilling. The indicator light sur-
rounding the temperature control will flash if the water tank is close to being empty.
Steam ironing
Steam ironing is only possible at high temperatures – indicated by the word “Steam” on the
temperature control. Please see the table above.
•
Make sure that the appliance is unplugged
•
Add water through the filling inlet (the water tank shall be at least ¼ full of water), cf. the
relevant section. Remember to set the steam selector at
first to prevent water from
running out right away.
•
Reinsert the plug into the socket at set the temperature control at the wanted tempera-
ture.
