47
• Make sure that the appliance is unplugged from the wall outlet. Add water
through the filling inlet; the water tank should be filled at least up to 1/4.
Remember first to set the steam selector at “0” to prevent water from running
out.
• Plug the switch to a wall outlet and set the wanted temperature and wait until
the signal lamp goes out.
• Finally, set the steam selector at optional amount of steam (1-3) and start
ironing.
Make a test on an old cloth or fabric to make sure that all possible impurities in
the water tank have been removed. Some parts of the iron have been slightly
lubricated/greased, which may create some smoke when you use the iron for
the first time. After about 10 minutes the smoke (which is completely harmless)
will disappear.
When steam ironing at low temperatures some dripping may be seen from the
soleplate as the water in the tank will not evaporate sufficiently fast. Consequently,
make sure to set the steam selector corresponding to the temperature setting.
Before you start ironing, press the spray and steam selectors 3-4 times to activate
these functions.
Burst of steam
Make sure that the water tank is filled at least 1/4. Set the temperature selector
at the wanted position between ••• and MAX and wait until the signal lamp on
the handle goes out.
Lift the iron a few centimetres from the garment and press hard on the burst of
steam button. The soleplate will now release a powerful burst of steam onto the
garment. It may be necessary to activate the burst of steam button a couple of
times in order to ensure the optimum power of the pump in the iron. Wait at least
4 seconds between each pressing.
Note that the burst of steam can only be activated at high temperatures and
when the steam selector is set at ”3”. If you want to have a more powerful burst
of steam, set the steam button at position “0”.
IMPORTANT!
If you use the steam function it is important to keep children away due to
the risk of burns. Keep your fingers off the jet of steam when this function
is on.
2118_IDV_UVN_020413 UDKAST.indd 47
4/18/2013 4:57:45 PM
