45
Safety Stop Function (only valid for OBH Nordica 2108)
The iron comprises a safety stop function that automatically switches off the iron
if you e.g. forget to switch it off after use. This function switches off the iron
if placed in a vertical position on its heel and has not been moved for about 8
minutes. If the iron is placed on the soleplate (i.e. in a horizontal position) and has
not been moved for 30 seconds, the iron is automatically switched off.
The safety stop light on the grip of the iron will start flashing, if the safety
stop function is activated. When you lift the iron, the safety stop light goes out
automatically and the thermostat light will flash to indicate that the iron is heating
up. When the iron has been heated up, you can start ironing again.
After use
When the ironing is done, put the steam selector in position “0”. Disconnect from
the mains supply and empty the water tank by opening up to the filling inlet
and turn the iron upside down over a sink to let the water run out. Reconnect
the appliance and set the temperature at “MAX” for 1 to 2 minutes to let any
remaining water evaporate. Now disconnect from the mains supply and position
the iron on its heel to let the soleplate cool off.
NOTE! Always position the iron on its heel when not in use!
Even the smallest
amount of liquid in the steam chamber may damage the soleplate, if the iron is
stored up with the soleplate facing downwards. Such damage is not covered by
the warranty.
Descaling procedure – cleaning the steam chamber
You will obtain the best ironing quality and the iron will last longer if the self-
cleansing procedure is followed at regular intervals, such as once or twice a
month, as this will remove possible scale and ”lint” in the steam chamber and in
the steam holes.
• Make sure that the plug of the iron is removed from the mains socket.
• Set the steam selector in position “0” (closed).
• Fill the water tank to the MAX water level.
• Place the iron on its heel.
• Set the temperature indicator at ••• and connect the plug in the socket and
branch the current.
• Let the steam iron heat up and wait until the thermostat light goes out and
then on and out once more.
• Unplug and keep the iron horizontally over a sink.
• Press the self-clean button and keep it pressed during the entire self-clean
procedure. The button may be a little tight – this does not mean that the iron
is defective.
2100_IDV_UVN_160413.indd 45
4/16/2013 5:14:53 PM
