71
If more than one transmitter has been installed, you can switch
from one transmitter to another on the display by pressing the
CHANNEL button. The transmitter showing the temperature
measurement is shown at the display of the receiver. The receiver
can automatically switch among temperature measurements from
the installed transmitters. To do this, press the CHANNEL button
until a small arrow icon appears in the bottom right corner of the
display.
Note!
If no signal is received from the transmitter for more than 3
minutes, ”--.- °C” will be displayed until the receiver again registers
correct reception. The following should be checked:
•
The transmitter works and has been correctly mounted.
•
The batteries in the transmitter and in the receiver work
perfectly. If not, change the batteries. Please note that when the
temperature drops to below the freezing point, the batteries in
a transmitter mounted outdoor, will freeze and be weakened.
If batteries have already been inserted in the transmitter and
in the receiver, press either the TX or the Reset button in the
battery compartment of the transmitter to receive signal from
the transmitter.
•
The transmitter and the receiver are not too far from each
other and other signals do not interfere with the temperature
transmission (e.g. from other electronic equipment, such as
alarm systems, door bells, computers etc.). If so, you may
shorten the distance between the transmitter and the receiver
or reposition the transmitter and the receiver in relation to
each other.
The wireless indoor/outdoor thermometer has a transmission
reach of about max 30 metres (measured in open land). However,
in urban areas the transmission reach will be shorter due to the
existence of other transmission installations (as described above).
4830_UL_UVN_100214 002.indd 71
2/14/2014 1:30:58 AM
