75
Setting of alarm
The wireless thermometer has two alarm functions (A1 and A2) that
can be connected in the following way:
1. Press the MODE button, until A1 (alarm 1) is displayed
2. Keep the SET/AL ON/OFF button down for 3 seconds and the
number of hours starts to flash.
3. Set the hours by means of the UP C/F or the DOWN 12/24
button at the wanted time.
4. Press the SET/AL ON/OFF button and the number of minutes
starts to flash. Set the minutes by means of the UP C/F or the
DOWN 12/24 button at the wanted time
5. Press the SET/AL ON/OFF button again and alarm 1 is set. A
small clock icon indicates that the alarm is set.
Alarm 2 (A2) is set and activated in the same way as alarm 1;
however, A2 shall be displayed instead of A1, when time is set and
the alarm activated.
When the wanted alarm time is in, the alarm will sound. If it has
not been switched off, the alarm will be on for about 2 minutes.
However, you can also switch off the alarm before it stops by itself
by pressing any button on the thermometer. The alarm will sound
again 24 hours later.
The clock comprises a snooze-function that is activated by pressing
the SNOOZE button at the back of the thermometer within the 2
minutes when the alarm is on. Subsequently, the alarm will be
repeated after about 5 minutes, until you switch off the alarm
completely by pressing any button.
If you want to disconnect the alarm function before it is activated,
press the MODE button, until A1 or A2 is displayed and then press
the SET/AL ON/OFF button. The icon will disappear from the display
and the alarm function is disconnected.
4830_UL_UVN_100214 002.indd 75
2/14/2014 1:30:58 AM