OBID
i-scan
®
UHF
Installation
ID ISC.ANT.U270/270-FCC
FEIG ELECTRONIC GmbH
Page 7 of 16
M30117-1e-ID-B
3. Installation
3.1. Mounting Holes
The antenna is designed for wall or fixture mounting. Mounting holes are provided in the housing.
Please note that only these holes should be used when mounting the antenna. An optional mount-
ing set is available to simplify the attachment of the antenna to portal structures or poles and can
be ordered from FEIG ELECTRONIC GmbH.
NOTE:
When fastening the screws it must be ensured that the housing of the antenna is not bend.
Optionally the attachment points should be supported by suitable washers or spacers
(Height 14 mm).
If mounted outside the preferred mounting direction of the antenna is vertical with the con-
nection cable towards ground.
Never mount the antenna in a way that the connection cable is guided to the top.
Figure 1: Mounting Drawing
CAUTION:
Bending radius of the connection cable: 15 mm (static) / 30 mm (dynamic)
230,5
230,
5
273
212
273
37
57,
5
Ø5,
5
