Mounting instructions, ZSE90 strain relief
EN | 13
Mounting the product
4 Mounting the product
The housing of the strain relief is fastened in the area of the clamp or
cable spacer clips. Then, it is filled with filling material and, depending on
the housing type, sealed with fire protection filler.
The housing of the strain relief can be fastened as follows:
– Directly on the wall with fire-tested bolt ties
– With slide nuts on profile rails and vertical ladder rungs
– On suspended vertical ladders on the vertical ladder rail with back
plate and lock plates
Possible fastening points for the housing, depending on the type of strain
relief and type and scope of the cable installation:
Type
Cable installation
Housing fastening
Type ZSE90-…
- Direct wall mounting with
cable spacer clips
- With profile rails and
clamp clips
- With vertical ladders and
clamp clips
- Directly on the wall
- On profile rails
- On vertical ladder
rungs
Type ZSE90-… L
- Direct wall mounting with
cable spacer clips
- With profile rails and
clamp clips
- With vertical ladders and
clamp clips
- Directly on the wall
- On profile rails
- On vertical ladder
rungs
Type ZSE90-…
LH
- With clamp clips on
suspended vertical ladder
- On vertical ladder rails
