Version 5.2_2022 (January 26, 2022)
20
8.2.2.
Horizontal transport
If the crane hooks are not used, use the fittings in the frame (so-called hoisting pockets). Use forklift prongs
with sufficient length. These should protrude through the frame. The use of chains is not recommended.
! CAUTION:
During transport by OC Verhulst, all openings as well as other connections are covered.
Leave this sealing intact for as long as possible to prevent dirt and moisture from entering
the unit.
All valves must be closed during transport by the rental company.
8.3.
Temporary storage
If the Aqua Cool cannot be set up immediately, all the medium and air openings must be temporarily closed
and all valves closed. If the Aqua Cool is taken out of operation for a longer period of time, the following
points should be noted:
•
The unit must be switched off properly (see chapter 9.1.
•
All dampers and valves must be closed.
•
If a glycol mixture is used, it must be drained off. This also applies to the cooler and defrosting
heater.
•
It is possible to stack the units on top of each other.
CAUTION maximum of 2 on top of each
other!
Equator (arm) L = 2700
Hoisting belt L = 3000
Harp shackle suitable for at least 6 kN
Aqua
Cool 100:
Total mass ca. 1300 kg
Length 2630 mm
Width 1220 mm
Height 2170 mm (2250 mm. including lifting eyes)
Forklift pockets.
Insert the spoons completely through the frame.
