Version 5.2_2022 (January 26, 2022)
23
9.
Starting
Before starting the unit, you can also view the external Quickstart.
The release of the unit comes from the clock programme and/or from the switch on the control panel. If the
controller does not present any limiting actions, the unit will start.
The following conditions must be fulfilled before starting the
Aqua
Cool:
If present, the hot water/cold water circuit must be adequately filled. Check whether there is air in the
water system and bleed if necessary.
If all of the above conditions are met, you can start your
Aqua
Cool:
! CAUTION:
Do not start the fans until the ducts and supply hoses and inlet covers (grilles) have been
correctly fitted, as any dirt sucked in will leave the fans at high speed!
Refer to the electrical diagram and the operating instructions of the control system to familiarise yourself with
the control of the unit.
Depending on the prevailing conditions, the unit will start in the desired operating mode.
When checking the operating conditions, reference can also be made to the values indicated on the
electrical diagram.
9.1.
Decommissioning
To decommission your Aqua Cool, carry out the following actions (see also chapter 8.3).
- Remove the start command from the control panel (see the electrical diagram).
- If there is a risk of freezing, OC Verhulst recommends that you drain the water circuit (if present) and
blow it dry using compressed air.
