Océ 3122 Copy
Copying Manual
This document provides information which is new or has changed compared
with the Océ 3121 manual.
Common remarks
■
The Fax Monitor key is always displayed in the Basic Features screen for
copying.
■
When using the Stack Bypass, press the [Paper Select] key and then the
[Stack Bypass] key.
■
The Film Projector is not available with the Océ 3122.
Page 3-27, Notice and 3-29, step 3:
To cancel [Number of Output PGS] and
change to [Copy Ratio(s)], cancel the Multi-page Enlarge mode using the
Reset key and then change the specification.
Page 3-35, Memo:
If the ADF or RDF is used and there are an odd number of
originals, the back of the last page is left blank. (The machine’s counter does
not count the blank page as a copy).
Page 3-37, step 4 and page 4-11, step 3:
If you place your original on the
platen glass the following messages appear on the touch panel display:
“Copying the 2nd side...”
Place the 2nd original and press the Start key again.
“Copying the 1st side...”
Page 3-45, Memo in step 2:
■
You can staple copies manually after they have been sorted, by using the
Manual Staple Mode.
■
If you are going to perform manual stapling for sorted copies of originals
placed on the platen glass, before copying turn Face Down Output “Off” and
then start copying from the last page.
Page 4-19, Memo in step 3:
The image will shift in the exact opposite
direction of the selected arrow.
Page 4-36, step 3:
■
When the RDF is attached: Select either [2 on 1], [4 on 1] or [2 on
1/Two-sided], then press the [Ok] key.
Summary of Contents for 3122
