Océ 3121 – Copying Manual – English
7-24
MEMO
●
When the previous projector settings are still available, the [SKIP
SHADING] key is displayed. If you press the [SKIP SHADING]
key, scanning for internally adjusting the Film Projector is
omitted.
3
Place the 35 mm positive film carrier on the projector
while following the on-screen instructions.
Holding the positive film carrier level insert the carrier
into the right-hand side as far as
mark on the side
of the carrier (so that the empty frame is aligned).
NOTICE
●
Leave the positive film carrier at this position until copying is
completed.
4
Set the lamp switch to the
position, and press
the [OK] key.
MEMO
●
When you turn the lamp switch ON, the Film Projector’s lamp
lights.
NOTICE
●
About 60 minutes after the lamp lights, it goes out. This is to
protect the film. To light the lamp after it has gone out, turn the
Film Projector’s power switch OFF then back ON again after a
short while.
5
After making sure that the lamp is lit, turn the light
adjustment dial to the left as far as it will go, and
press the [OK] key.
Summary of Contents for 3122
