Océ 3121 – Copying Manual – English
2-22
Interrupting the Current Copy Job to Make
Priority Copies
(Interrupt Mode)
The Interrupt mode enables you to stop the current copy job long enough to make other priority copies.
This mode comes in useful when making a rush copy during a continuous copy job.
MEMO
●
When using the Interrupt mode, place your originals on the platen glass. Originals cannot be scanned from the
ADF/RDF.
●
There are five modes or settings which can be set in the Interrupt mode:
·
Adjusting Exposure Setting and Image Quality (See p. 3-8.)
·
Enlarging/Reducing Originals from Standard Paper Sizes to Another (See p. 3-12.)
·
Reducing/Enlarging Originals to the Desired Size (See p. 3-14.)
·
Selecting the Copy Paper Size (See p. 3-2.)
·
Entering the Copy Quantity (See p. 2-20.)
●
Auto Clear is not carried out while the Interrupt mode is set.
●
Up to 100 copies can be made in the Interrupt mode.
1
Press the
key.
When you press the
key, it begins flashing.
After the current copy job has stopped, the touch
panel display changes as shown on the right, and
the
key stops flashing and stays lit.
MEMO
●
If a department ID was being used to run the current copy job,
the screen for entering the department ID and password
appears. (See ”Entering the dept. ID and password,” on p. 2-10.)
When managing copying using the control card, the control card
must be inserted before using the Interrupt mode. (See ”Inserting
the Control Card,” on p. 2-8.)
2
Lift up the platen cover/ADF/RDF.
NOTICE
●
If the interrupted copy job was being run using the platen glass, temporarily remove the original from the platen
glass.
●
If the interrupted copy job was being run using the ADF/RDF, slowly lift the ADF/RDF so that none of the
originals fall out of the original supply tray.
Summary of Contents for 3122
