Procedure
1.
Place media on the table at the desired location.
NOTE
To place media at the print Origin B (Origin A is the default) you need to set that up either in the
ONYX software or after the job is sent in the Print Job screen (this is explained in the next
section "How to Print with Dual Origin").
2.
Mask off any areas of the active vacuum zone(s) that will not be occupied by the media.
NOTE
The media can occupy more than one zone, but if a zone will be active, all of the area not
covered by the media must be masked so that all vacuum holes are covered.
If the Center Zone is not occupied by media it can be turned Off with the manual valve located at
the Zone 1 end of the printer.
3.
Activate the zones you wish to use either with the icon on the command bar of the Print Job
module or with the matched foot switch (A or B) on the floor.
4.
Start the print job either with the Start icon on the command bar or with the Print Start button
located near the vacuum gauges.
5.
De-activate the zones with either the icon or the foot switch once the image is printed.
6.
Remove the media.
How to Use the Océ Arizona 600 Series XT Vacuum System
Chapter 6 - How to Operate the Océ Arizona 600 Series XT
85
Océ Arizona 600 Series
Summary of Contents for Arizona 640 GT
