Procedure
1.
Select the Load icon from the Roll Media Manager.
2.
If you are going to print with "Print Side In", click the icon in the Roll Media manager ("Print Side
Out" is the default so you do not need to select it unless you have previously used Print Side In).
Note that the icon toggles from one choice to the other when you click it.
NOTE
For Print Side Out, the media unrolls from the bottom the supply shaft.
For Print Side In, the media unrolls from the top of the supply shaft.
3.
Wait for the gantry to move part way across the table.
4.
Thread the media under the media tension bar (Note that the media is threaded for Print Side Out
in the photo below). Pay out media with the foot pedal as required.
[62] Thread Media Under Tension Bar (Print side out)
5.
Open the media access door at the top of the Roll Media unit, then reach down through the open
door to grasp the media and feed it up and over until it reaches the take-up roll.
[63] Feed Media Through Access Door
6.
Check alignment of the media by feeding it down to the supply roll and make sure that the edge
lines up with the edge of the supply roll.
Loading the Media - Standard Method
Chapter 7 - How to Operate the Roll Media Option
99
Océ Arizona 600 Series
Summary of Contents for Arizona 640 GT
