Océ | System Requirements
2-14
3010102253-B
2.6.6
Host Computer Requirements
The Arizona T220UV requires Onyx PosterShop
®
front-end software. It is the customer's
responsibility to procure and configure computer hardware which, at the minimum, meets
the software's basic computational and data handling needs. The printer includes a standard
10 meter SCSI cable for data transfer, and also a 25 ft RS-232 serial cable to load firmware
and to transfer test prints (can also use a Centronics parallel cable for this).
Onyx PosterShop
®
Host Requirements
Onyx PosterShop
®
software is used to generate the print files that are downloaded to the
Arizona T220UV. The following are the PosterShop
®
computer’s suggested
minimum
hardware requirements.
•
Intel CPU 1.5 Ghz or higher
•
40 GB IDE, 7200 RPM hard disk (For System)
•
36 GB, 10000 RPM SCSI drive (For PosterShop & Data)
•
LVD-SCSI 68pin Adaptec 29160 Host Adapter card installed.
•
100 Base-T network interface card
•
One USB port required for Security Key
•
DVD-ROM drive suggested, 40x CD-ROM minimum required.
2.7
Operator Training
Maximum performance on the Arizona T220UV requires a properly trained operator. Océ
trains the operator in the use of the Arizona T220UV hardware and software at installation.
However, this is not a substitute for formal PosterShop
®
training.
Operators of the Arizona T220UV should be fully versed in the operation of Onyx
PosterShop
®
. For any operator unfamiliar with its operation, Onyx PosterShop
®
training
is required. On-site or off-site training courses are available; contact Onyx Graphics
Corporation for more information:
Visit http://www.onyxgfx.com/support_training.html
or
call 1-800-828-0723 (in North America).
Note:
Please refer to the Onyx web site for the suggested hardware and operating
system requirements for the most current version of PosterShop.
http://www.onyxgfx.com/solutions_postershop.html
