68
Chapter 5 Error Conditions, Problems and Solutions
Clear a Stitch Wire Jam
Before You Begin
[39]
Clear the Jammed Wire
[40]
Step
Action
Information
1
Turn off the BLM500
Use the mains ON/OFF switch.
2
Disconnect the BLM500 from the
mains power supply.
3
Lift the BLM500 main deck
Step
Action
Information
1
Cut the stitch wire at position
'A' approximately 50mm
(2-inches) from where the
stitch wire leaves the
stitch-wire guide.
[32]
Detail A: Cut stitch wire here.
2
Cut the stitch wire at position
'B' between the feed gears
and the middle wire tube.
[33]
Detail B: Cut stitch wire here.
3
Pull the stitch wire from the
stitch wire guide block.
[34]
Pull stitch wire in direction of arrow
4
Pull the stitch wire from the
middle wire tube.
Stitch Head.. If there is not enough
stitch-wire left to pull, then follow the
procedure(
Wire from the Stitch Head’ on
page 91
5
Install the stitch wire into the
stitch head.
see ‘Install the Stitch Wire into the
A
B
Summary of Contents for BLM 500
