64
Chapter 5 Error Conditions, Problems and Solutions
Clear Paper Jams
Jam before the Trimmer
[35]
Jam in the Trim Area
[36]
Step
Action
Information
1
Open the Océ BLM500 main
deck
2
Remove the trim bin.
3
Remove the trimmer infeed
conveyor.
The procedure can be seen from the
top of the machine. Access to the parts
is through the trim bin opening. Hold
the shaft and push to the right, against
the spring pressure. Lift the left hand
end clear.
[30]
4
Remove the book.
5
Remove any paper offcuts from
the trimmer infeed conveyor.
A small piece of paper can cover the
jam sensor and generate an error
message.
6
Fit the trimmer infeed conveyor. Insert the right hand end of the shaft
into the bearing, against the spring
pressure. Insert the left hand end.
7
Fit the trim bin.
8
Close the Océ BLM500 main
deck and covers.
9
If there is paper in the gathering
area, touch PURGE SET.
This action clears paper from the Océ
BLM500.
10
Continue the print job.
Step
Action
Information
1
Remove the trim bin.
2
Loosen the 2 orange plastic
hand screws to release the
locking plates.
The locking plates can rotate to
release the trim stop guard.
3
Pull the trim stop guard
towards you.
Summary of Contents for BLM 500
