2-12
Basic
Mode
Using the Control Panel Keys
Interrupt
When the
key is pressed, the Interrupt mode is activated. Press this key to stop
the current copy job and begin another copy job.
The following modes and settings can be specified in the Interrupt mode:
· Copy quantity
· Preset Zoom
· Center shift
· Original Type
· Zoom
· One Touch Color
· Copy Exposure Adjustment
· Auto Zoom
· Color Balance
· Paper Selection
· XY Zoom
· Image Quality Adjustment
· ACS/Full Color/Black
· Zoom Program
· Sharpness
· Original Size Recognition
· Entire Image
· Margin
· Frame Erase (Sheet Frame, Original Frame)
The Interrupt mode cannot be selected during a Composition copy job. Also the Interrupt mode
cannot be selected during another interrupted copy, recovering, or Auto Start copy job.
■
When Placing an Original on the Platen Glass
1
Press the
key.
When the
key is pressed, its indicator starts blinking.
1
2
3
4
5
6
7
8
9
ID
0
C
Reset
Guide
Additional Functions
Interrupt
Clear
When the current copy job has stopped, the message
"Ready to perform interrupt job." appears on the Touch
Panel Display. The blinking
key indicator is retained
ON (Interrupt mode).
❚
If a department ID and/or a
password are already registered,
the screen appears to prompt
you to enter the registered ID
number. Enter the correct
department ID number and
password. For details, see
"Entering the Department ID
Number and Password," on
p. 2-4.
❚
To cancel the interrupt copy
during setting, press the
key.
