Scanner installation
17
▼
To connect the scanner to the computer
1
Check at the back of the scanner for the SCSI termination. If the scanner is the
last device
on the SCSI bus, turn on
switch 4
, the built-in active SCSI
termination. If the scanner is not the last device, make sure switch 4 is off.
Attention:
Do not turn on switch 4 and use a terminator block at the same
time.
2
Switch off your computer and your scanner.
3
Disconnect the power cord.
4
Connect one end of the supplied SCSI cable into the SCSI board connector at
the back of the computer.
5
Connect the other end of the SCSI cable to one of the two SCSI connectors on
the back of the scanner.
6
Set up the scanner SCSI address.
SCSI address setup
You set the SCSI device number on the DIL switch behind the scanner.
▼
To set up SCSI device address
1
Power off the computer and the scanner.
2
To locate the DIL switch, slide the streamer on the front of the scanner to the
left.
3
Press the ‘Push’ button to slide out the ‘smart card’ holder.
4
Remove the ‘smart card’ to access the switch.
Note:
Remember to replace the ‘smart card’ before you turn the scanner
back on.
5
Select an unused SCSI device address number according to the table below.
SCSI device
no.
Switch
1
2
3
4
5
6
7
8
0
ON
ON
ON
-
-
-
-
X
1
OFF
ON
ON
-
-
-
-
X
•2
ON
OFF
ON
ON
OF
F
OFF
OFF
X
3
OFF
OFF
ON
-
-
-
-
X
4
ON
ON
OFF
-
-
-
-
X
5
OFF
ON
OFF
-
-
-
-
X
6
ON
OFF
OFF
-
-
-
-
X
7
OFF
OFF
OFF
-
-
-
-
X
