Truncate the job name
Introduction
The operator panel displays all print and copy jobs with their job names in the 'Jobs'
view. If a job name is too long, the system truncates the job name. To enable you to
identify your jobs in the lists more easily, you can define how the system truncates the
job names. This allows you to keep the identifying part of the job name. You can choose
to truncate the job name at the beginning or at the end of the name.
Illustration
[71]
How to truncate the job name
1.
On the operator panel, press the 'System' button.
2.
Press 'Setup'.
3.
In the 'User interface' section, press the 'Job name truncation' button.
4.
Press the 'Job name truncation' button to change the truncation method.
You can choose to truncate at the 'Beginning' or the 'End' of the job name.
5.
Press the - or + button to change the number of characters before truncation.
Chapter 5 - Working with the operator panel
129
Truncate the job name
Summary of Contents for VarioPrint 6000 MICR series
