Output locations
Introduction
If a stack of folded sheets is too high, the stack will tilt. Therefore, the system limits the
number of folded sheets per output location. How the system limits the output capacity
depends on the folding method.
Z-fold
• Depends on media weight and type.
• Depends on the percentage of folded sheets in a stack.
Half-fold
• Determined by a fixed number of folded sheets.
The default settings guarantee safe stacking for media up to 100 g/m² or 27 lb. bond for
plain media or 120 g/m² or 32 lb. bond for coated media. You can adjust the stack height
for heavier media in the Settings Editor. You can change the stack height in increments
of 10% from -50% to +200%. For heavier media, start with -50% to prevent stacks tilting.
The table below gives an overview of the default capacity per output location for half-
folded and Z-folded sheets.
Z-fold
Output capacity for Z-folded sheets
#
Finisher (number of sheets)
Stacker (number of sheets)
Percentage of
folded sheets
(%)
4000
6000
1
3000
3200
2
2250
1980
3
1320
1080
5
510
400
10
273
280
14
144
160
25
Chapter 6 - Optional finishers and other devices
203
Output locations
Summary of Contents for VarioPrint 6000 MICR series
