Ocean Digital WR-230S, User Manual

6

2. Network Setup

Internet connection can be setup via Wired LAN or Wireless LAN (WiFi).
Your Radio requires a broadband Internet connection through wired Ethernet or 
WiFi. The easiest way is use a CAT 5 or CAT 6 cable to connect through wired 
Ethernet to a Wifi router, which connects to an Adsl modem or a cable modem 
provided by your ISP.

WPS connection is available if your router has a WPS button.
To configure the network via remote app, see Chapter 12 for more details 
[under Wi-Fi Network > Add AP (SmartConfig)].

Wired LAN (Ethernet)

For Wired Ethernet connection to a router with DHCP enabled, the network 
configuration for Internet connection is automatically done and the Radio can be 
used for Internet radio and UPnP sharing without user interaction. When the 
network is connected, the Ethernet icon        will appear on the top left corner.

Wireless LAN (Wi-Fi) 

• If this is first time use, the Configure Network wizard will be displayed. Choose Yes 

to start configuring network. Press the 

[ ◄ ]

 button to highlight Yes and press 

[Tune/Select]

 to confirm.

• Select Add/Remove AP from the list, use the 

[Tune/Select]

 knob to scroll and 

press it to confirm, then choose Add AP (Scan):

• It will start scanning the available Wi-Fi routers around. Scroll to your network and 
press

 [OK]

 to confirm. If your wifi network has a security code protected, it will ask 

you to enter the passphrase/password. Please refer to the above section '

How to 

input security code for your wireless network

' on P.3.

Note: The password is case sensitive. Please consult with the one who setup your 
network if you don't know the password.

• When the Wi-Fi connection is successful, the Association Complete will be shown 

briefly. The wifi signal bar will appear on the top left corner of the display: 

Configure Network?

     <

Yes>    No

Add AP

Remove AP

Add/Remove AP

AP:[  ]

Wi-Fi signal bar