Note:
1) If the current input has signal, the device will not auto switch to other input when rebooting, it will
keep the current input.
2) When all inputs have no signal, device saves last switch port when rebooting.
3) The priority mode is only valid when the device has signal input.
RS232 Pass through
By RS232 Command, the OMX-07MXMX0001 switch can send RS232 data to control the receivers,
also the receiver can send RS232 data to control the OMX-07MXMX0001 switch.
Please refer to the command list which is included in the manual
Micro USB for Firmware Upgrade
MCU application layer upgrade
1) The user should use the CD in colorbox, read and install software "UART_ISP.exe" on PC;
2) Connect unit to PC with USB cable from micro USB port,click "UART_ISP.exe" software,
REFRESH and choose correct COM port that connect to product,and baudrate 115200(default).The
baud rate setting is consistent with the host baud rate.
3) Type in “A1” in PORT and choose update program file in PATH,then click UPDATA wait for
update until it prompt “Succeed” informations and upgrade completed:
GUI Application Layer Upgrade
1). Connect unit to PC with USB cable from micro USB port,click "UART_ISP.exe" software,
REFRESH and choose correct COM port that connect to product,and baudrate 115200(default).The
baud rate setting is consistent with the host baud rate.
2). Type in “A1 01” in PORT and choose update program file in PATH,then click UPDATA wait for
update until it prompt “Succeed” informations and upgrade completed:
