GSM CUBE³ manual rel.1.0
15
PRECAUTIONS
Do not use solvents (such as diluents) to clean the unit. They
can cause irreparable damage. Only use neutral detergents.
Use running water to remove the seawater from your GSM CUBE³
after use. The system must be kept completely dry and in good
condition.
Do not twist the microphone cable.
Do not expose the unit to direct sunlight.
Do not leave the unit in your car.
Do not keep the unit in places that are too hot or too cold, such
as near air conditioners.
Do not keep the unit near magnetic fields.
Do not allow it to fall or be knocked around.
Replace the battery when it is running low. When not using the
unit for extended periods of time, remove the battery from its
housing to prevent damage.
Only use 9V alkaline batteries. Install them in the battery
housing, ensuring that they are of the correct charge and
polarity. Do not activate the polarity circuit using metal wires or
pieces of metal.
Make sure there is no dirt, debris or water in any part of the
unit, especially in the battery housing or under the O-ring. If
any dirt, debris or water is found, remove it.
When replacing the battery check the O-ring for damage. If it is
damaged, replace it. The O-ring must be lubricated with a thin
layer of silicone lubricant.
Do not dismantle or repair this unit by yourself.
Follow the instructions for correct maintenance of the
microphone and battery housing, given in previous chapters.
If the battery compartment should be flooded, remove the
battery, rinse the compartment with fresh water and leave to
dry. Remove any debris, and clean the spring contacts, then
install a new battery. If the unit does not function, check the
state of the microphone.
Summary of Contents for GSM Cube 3
Page 1: ...OWNER S MANUAL ...
Page 2: ...GSM CUBE manual rel 1 0 2 ...
